Home Solar Panel DIY

Making a home Solar Panel is not hard! Click Here For Videos and More Information! Although the manufacture of solar panels is done in a strict quality controlled environment, for personal purposes you can build your own home solar panel to see how the sun’s energy can be converted to electricity. While most commercial panels are actually made with silicon, you can build your own home solar panel by using cuprous oxide - copper- which causes light to be turned into electricity. Using a thin sheet of copper, you can get your cuprous oxide. Here's how:.

Click Here For Solar Panel Videos and More Information on home Solar Panel building!

Here's the list of what you need to make your own home solar panel: one square foot of thin copper plate, two alligator clips and short leads of wire, a wide mouth glass jar, tap water and salt. By using a voltmeter, capable of measuring extremely small amounts of electricity, you can see the end result. The copper sheeting needs to be heated on an electric stove or hot plate, to build your own solar panel. It's as simple as putting the copper sheet on a burner. Turn it on high and let it heat up there for about 30 minutes. As the plate heats up, you will see it turning colors, because the heat shows the outline of the heating coil underneath. As it gets hotter it will start to turn a dark color until the whole sheet has a very dark, even black coating.

When the entire sheet is black, turn off the burner and let it sit to cool for about 20 minutes. The now black cuprous oxide cools, and the black coating will start to pop off the sheet, leaving a thin coating of red on the copper. To build your home solar panel the red coating is what is needed. Most of the black can be rinsed off under running water, but it should not be brushed clean.

Salt Water actually Helps Produce The Electricity for your home solar panel. By using the alligator clips, connect the copper sheet to one the top of one side of the glass jar. Attach the other clean copper sheet to the other side of the jar. Mix 2 tablespoons salt into hot water, make sure it dissolves then pour it into jar. It's really important that the water does not get on the alligator clips. The two copper sheets should be under water with about one inch left exposed at the top of the car to build your own solar panel.

Hey, now you are getting closer to your home solar panel. Carefully place the entire contraption in the sunlight, either in front of a window or carry it outside and expose it to the sun. If you were able to build your home solar panel, you can see the meter indicate the power being generated by sunlight. Using the voltmeter connect the leads to the two alligator clips. Enjoy the sun's energy from your own home solar panel! You can feel glad!!! Click Here For Solar Panel Videos and More Information